Getting Started Figure Removal and Insertion of the Memory Cartridge Insert the memory cartridge into the cartridge slot, label side towards the center of the printer. Check for Out-of-Media condition or missing labels in the middle of a roll. The family driver names, as they appear in the Model field in Loftware Label Manager , are listed in the Printer Language columns. Swing the bracket down. Page 46 Operation Battery Replace the battery by lifting the battery retain- ing clip up and inserting the new battery in with Replacement Step 4 the printed side up. Got it, continue to print.

Uploader: Munos
Date Added: 28 January 2012
File Size: 43.7 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 18751
Price: Free* [*Free Regsitration Required]

Thermal Transfer Cross Reference

Print Density Windows Printer Driver Eltron tlp 2046 Quality, The print speed can be adjusted to compensate for manufacturing differences in label stock. The printer driver is installed and ap- pears in the Installed Printers list in the Printers dialog box.

Got it, continue to print.

The first trouble shooting reference source is the Tllp Problems Trouble Shooting table on the following page. Loading either labels or tags eltron tlp 2046 easy, the feed direction of tags is different.

Lift To Open Remove the tape securing the label rewind clip to the label rewind tube. Refer to Appendix B for complete supplies ordering information. Matrix of all Barcode Printers that Loftware eltron tlp 2046. Placing this switch eltron tlp 2046 the ON 1 position elteon apply power to the printer. Slide the Replacement Step 3 casing top cover off.

Trouble Shooting Guide 2.

Thermal Transfer cross reference list

eltron tlp 2046 The TLP has a 4 inch print width, dpi print resolution and up to KB user config- urable memory. Getting Started Step 4 Eltron tlp 2046 printer has a manual configuration switch bank located on the back panel of the printer. If your barcode printer or printer language is not listed here, please call Use only Eltron approved labels and tags. Place this switch in the OFF 0 position to remove power when you have finished using your printer.

Page 48 Operation Rev. This manual also for: Push the roll to the back of the support and slide the Label Roll Guide against the label roll to hold it in place. Rewind Mode Step 1 Thread the label stock, liner only for the label auto-dispense modearound and below the Platen Roller Assembly. Select the TLP driver that represents your printer. Operation Transfer Ribbon Open the printhead assembly. If your printer or printer language is not listed here, please call Eltron tlp 2046 printhead assembly will pop open.

Page 6 Rev. Step Place the printer in a suitable location that Attach Power allows easy access to all sides of the printer.

Attach the ribbon to the rewind core fiberboard tube on the ribbon take-up tube with tape. Warranty Information, Fcc Notice 12 months from the date of purchase by the end user. Table Of Contents Introduction Push the cartridge slowly and firmly, until it stops, to engage. Figure Attaching Eltron tlp 2046 Tape Getting Started Figure Removal and Insertion of eltroon Memory Cartridge Insert the memory cartridge eltron tlp 2046 the cartridge slot, label side elrron the center of the printer.

Figure Electrical Outlet Insert Don’t show me this message again.

Figure Notches Lock the bracket into place with the thumb Page of 68 Go. Direct Thermal – without transfer ribbon Thermal Transfer – with transfer ribbon Turn the thumb screw eltron tlp 2046 Rewinding Step 2 the bracket to the printer chassis counter clock- wise to loosen.

The door has a magnetic latch for easy access. Operation Label Variations Your TLP is equipped with a sensor ca- pable of detecting the gap eltron tlp 2046 labels while and the they are being printed.